Модуль Cisco 7600-SIP-400

 ●  TCP
●  User Datagram Protocol (UDP)
●  IPv4 Unicast and Multicast
●  IPv6 Unicast and Multicast
●  Multiprotocol Label Switching (MPLS)
●  SAToP and CESoPSN

●  Frame Relay
●  Point-to-Point Protocol (PPP)
●  High-Level Data Link Control (HDLC)
●  ATM permanent virtual circuit-constant bit rate (PVC-CBR), variable bit rate real-time (VBR-rt), VBR non-real-time (VBR-nrt), and unspecified bit rate (UBR)
●  ATM switched virtual circuit (SVC)-CBR, VBR-rt, VBR-nrt, UBR, UBR+
●  TDM over MPLS, ATM over MPLS, and ATM over GRE
●  L2TPv3

QoS, ACLs, and Low-Speed Aggregation Features
QoS
●  Modular QoS CLI (MQC)
●  Classification based on:
◦   IP Precedence (IPv6 and IPv4)
◦   Diffserv code point (DSCP) (IPv6 and IPv4)
◦   MPLS experimental values (MPLS EXP)
◦   Extended ACL
◦   ATM CLP
◦   Frame Relay DE
◦   Class of Service (CoS)
◦   VLAN
Congestion Avoidance
●  Weighted Random Early Detection (WRED) based on IP Precedence, DSCP, MPLS EXP, ECN (mark IP TOS field for POS traffic)
Queuing
●  Congestion management
◦   Per-virtual circuit queuing
◦   Ingress and egress Low-Latency Queuing (LLQ)
◦   Egress Class-Based Weighted Fair Queuing (CBWFQ)
Traffic Classification, Shaping, and Bandwidth Policing
●  Marking
●  Policing
●  Distributed traffic shaping (DTS)
●  Hierarchical service policies
Security
●  Standard and extended ACLs
Layer 2 and Layer 3 VPNs
●  Ethernet over MPLS (EoMPLS)
●  ATM over MPLS (ATM over MPLS)
◦   ATM Adaptation Layer 5 (AAL5) virtual circuit mode, single and packed cell relay virtual circuit mode
●  Frame Relay over MPLS (FRoMPLS)
●  Layer 3 MPLS/VPN over GRE
●  ATM over GRE, Ethernet over GRE
●  TDM over MPLS
High availability
●  IPv4 Nonstop Forwarding (NSF)
●  IPv4 Stateful Switchover (SSO)
●  Automatic Protection Switching (APS) with ATM, POS SPAs
●  OIR for both SIP and SPA
Multilink support
●  Frame Relay Multilink^1 (1) Added in >15.2(04)S

1 GB default Double Data Rate (DDR) synchronous dynamic RAM (SDRAM) per Cisco 7600 SIP-400

●  Operating temperature: 32 to 104°F (0 to 40°C)
●  Storage temperature: -40 to 167°F (-40 to 75°C)
●  Relative humidity: 10 to 90 percent, noncondensing
●  Operating altitude: -60 to 2000m

●  Cisco Entity MIB (CISCO-ENTITY-MIB)
●  Cisco Entity Asset MIB
●  Cisco Entity Field-Replaceable Unit (FRU) Control MIB
●  Cisco Entity Alarm MIB
●  Interface IF MIB (RFC 2233)
●  Frame Relay MIB (RFC 1315)
●  Cisco Frame Relay MIB
●  ATM MIB (RFC 1695)
●  Definitions of Managed Objects for Bridges (RFC 1493)
●  Evolution of Interfaces Group of MIB-II (RFC 1573)
●  SNMP MIB II (RFC 1213)
●  Remote Monitoring (RMON) MIB (RFC 1757)
●  Switch Monitoring (SMON) MIB

Supported with CiscoWorks CiscoView
CiscoWorks Resource Manager Essentials (RME)
Cisco IP Solution Center (ISC)

●  Occupies one slot in a Cisco 7600 Series router
●  Supports up to 12 Cisco 7600 SIP-400s in a 13-slot chassis
●  Requires Supervisor Engine 720-3B or 720-3BXL
●  Dimensions (H x W x D): 1.75 x 15.375 x 16 in.
●  Weight: 16 lbs not including the packaging

185W power consumption per Cisco 7600 SIP-400
265W maximum power consumption with 4 SPAs

●  UL 60950
●  CSA C22.2 No. 60950
●  EN60950
●  TS001
●  IEC 60950
●  AS/NZS3260
●  UL60950

●  FCC Part 15 Class A
●  ICES-003 Class A
●  VCCI Class A
●  EN55022 Class A
●  CISPR22 Class A
●  AS/NZS3548 Class A
●  EN61000-3-2
●  EN61000-3-3
●  EN61000-3-1
●  EN55024
●  EN50082-1
●  EN300 386

●  TU-T G.610
●  ITU-T G.703
●  ITU-T G.707
●  ITU-T G.783 Sections 9-10
●  ITU-T G.784
●  ITU-T G.803
●  ITU-T G.813
●  ITU-T G.825
●  ITU-T G.826
●  ITU-T G.841
●  ITU-T G.957 Table 3
●  ITU-T G.958
●  ITU-T I.361
●  ITU-T I.363
●  ITU I.432
●  ITU-T Q.2110
●  ITU-T Q.2130
●  ITU-T Q.2140
●  ITU-T Q.2931
●  ITU-T O.151
●  ITU-T O.171
●  ETSI ETS 300 417-1-1
●  ACA TS 026 (1997)
●  BABT/TC/139 (Draft 1e)